We're the innovator of the
Vermont Release Calibrater
- CALIBRATER INSPECTION
- BUY TODAY!

Welcome to

Vermont Ski Safety Equipment Inc.

The Vermont Release Calibrater is a fully integrated installation and inspection station that is designed to measure the release torque of the Alpine ski and boot to binding systems. It can also be used to install and service bindings prior to inspection. Learn more »

2024 Spring Specials

How often do I have to inspect my Calibrater Arm (Torque Wrench)?

Routine Visual Inspection: Visually Check the Calibrater Arm each day before use. If deficiencies are noted, consult the Maintenance and Repair section of the Calibrater Manual. Most routine maintenance and component replacement operations can be performed in shop. When returning the Arm to the factory for annual calibration inspection or repair, other Calibrater components do not need to be returned to the factory except as required.
Calibration Check: At the beginning, and at least once during the season, the calibration of the ARM should be verified using a dead weight. See Appendix II of the Calibrater Manual. Any weight used should be checked on a state or federally certified scale. Calibration checks should also be made whenever the accuracy of the Calibrater is called into question.

More FAQs

There are many ways in which knee injuries can occur in skiing, we concentrate on the two most common scenarios, the Phantom Foot and the Boot induced.

Avoid high risk behavior
Routinely correct poor skiing technique
Recognize and Respond quickly and effectively to potentially dangerous situations
Don't jump unless you know where and how to land

Keeping Skiers Safer Since 1971

We're the innovator of the
Vermont Release Calibrater

Welcome to

Vermont Ski Safety Equipment Inc.

2024 Spring Specials

Equipment

Research

Development

We're the innovator of the Vermont Release Calibrater

Welcome to

Vermont Ski Safety Equipment Inc.

2024 Spring Specials

We're the innovator of the
Vermont Release Calibrater